'Xeriscape’ is a landscape method that promotes water conservation. Rather than focusing on a specific 'look' or using a limited group of plants, Xeriscape is a combination of seven basic landscaping principles.
These principles are explained below in the order a landscape planner or property owner would consider to install the best landscape. Each principle must be considered during the planning and design phase, but the sequence of installation is also very important in assuring a successful Xeriscape.
The Seven Principles of Xeriscape
1. Planning and Design
- Existing lawn, garden, shrub masses and flower beds
- Trees (both yours and your neighbors, if they shade part of your yard)
- Slopes, their grade and compass orientation
Trying to create a landscape without a plan is like trying to build a home without blueprints. A plan provides direction and guidance and will ensure that water-conserving techniques are coordinated and implemented in the landscape.
The first step is to look at your existing landscape and create a "base plan." This is a to-scale diagram showing the major elements of your landscape – your house, driveway, sidewalk, deck or patio, existing trees, etc.
To measure your landscape, you'll need a 50-foot or longer tape measure, and a helpful relative or friend. You will need to measure from the property lines to your house, as well as all the exterior walls of your house. You will also need to measure other impervious surfaces, such as sidewalks, decks and driveways. If there are existing trees, shrubs, etc. that you wish to keep, you'll need to measure to place them accurately in your plan.
Once you've recorded all the measurements, you'll have to transfer them to graph paper. Most designers prefer to work with plans drawn to a 1:10 or 1:8 scale. This means that every 10 (or 8) feet of actual measure equals 1 inch on your plan. So if your property is 50 feet wide by 100 feet long and you're using a 1:10 scale, your plan would be 5 inches by 10 inches.
Once you've drawn your property lines on the graph paper, you need to fill in the details, including the house outline, sidewalks, driveways, etc. You also need to show direction on your plan by drawing an arrow indicating North.
This will help your designer select plants appropriate for specific exposures. Some of the other things you should include on your base plan are: the location of spigots, downspouts and external electrical outlets, fences, walls and other structures.
Once you've completed a base plan of your existing landscape, you need to think about how you want to use your new Xeriscape. Examples of uses can include a place to let the dog romp; an inviting approach to your front entrance; the selection of a tree to block an unsightly view; the placement of a vegetable garden and so on.
The final step is to develop a "planting plan," indicating what types of plants should go where in your yard.
2. Soil Improvements
Front Range soils tend to fall into one of two categories: sand and clay. Clay soil is dense, slow to absorb and release water. If water is applied to clay soil too quickly, it either pools on the surface or runs off. Over watering heavy clay soil can actually drown plants. Sandy soil can't hold water. Unless irrigated frequently, plants in sandy soils tend to dry out. To enable your soil to better absorb water and allow for deeper roots, you may need to add a soil amendment before you plant. For most soils, adding 1 to 2 inches of organic matter such as compost or well-aged manure to your soil can be beneficial. Rototill the organic matter into the soil at least 6 inches deep.
Before amending soils one must decide what the majority of plant species are that will be used. Native western plant species have evolved to not need high organic content. Many of the native western species actually will die or be short lived with too much organic matter. Besides being mineral in nature western soils also tend to be alkaline in pH. Many soil amendments that are traditionally used (humus, compost, lime, wood ash) simply are not needed for western water wise gardening. Because western native species have evolved in the mineral rich western soils adding trace minerals to the soil may be beneficial. Most often no soil amending is necessary. Performing a soil test will confirm the amount of trace minerals that are available for the plants to utilize.
Along with soil chemistry, good drainage is very important for many western native plants. From my experience one can adapt Midwest or eastern natives to the west easier than trying to make western species work in a moist environment. The caveat in this endeavor is one must use copious amounts of water to grow Midwest species in the arid west; not a good idea. The western natives perform very poorly when subjected to more irrigation than they need, even with good drainage.
3. Efficient Irrigation
A Xeriscape can be irrigated efficiently by hand or with an automatic sprinkler system. If you're installing a sprinkler system, it's a good idea to plan this at the same time you design the landscape. Zone turf areas separately from other plantings and use the irrigation method that waters the plants in each area most efficiently. For grass, low-pressure, low-angle sprinklers irrigate best. Drip, spray or bubbler emitters are most efficient for watering trees, shrubs, flowers and groundcovers. If you water by hand, try to avoid oscillating sprinklers and other sprinklers that throw water high in the air or put out a fine mist. The most efficient sprinklers put out big drops and keep them close to the ground. The most efficient method to apply water is through some type of drip system. Many systems are on the market and the best types use controlled flow rates through emitters The best subsurface systems also have check valves at the emitters to regulate flow through the irrigation line, ensuring that the last emitter will have the same flow as the first emitter on the line.
Water deeply and infrequently to develop deep roots. The best time to water is between 9 p.m. and 9 a.m. to reduce water loss due to evaporation. If you have an automatic sprinkling system, adjust your controller regularly to meet seasonal needs and weather conditions. Also, install a rain shut off device.
4. Zoning of Plants
Different areas in your yard get different amounts of light, wind and moisture. To minimize water waste, group together plants with similar light and water requirements, and place them in an area in your yard which matches these requirements. A good rule of thumb is to put high water-use plantings in low-lying drainage areas, near downspouts, or in the shade of other plants. It's also helpful to put higher water-use plants where it is easy to water.
Dry, sunny areas or areas far from a hose are great places for the many low water-use plants that grow well in our climate. Planting a variety of plants with different heights, color and textures creates interest and beauty.
By grouping your plants appropriately (similar moisture, sun or exposure requirements), you will minimize water waste while ensuring that your plants will flourish in the right environment. Otherwise one will end up watering enough to satisfy the species with the greatest water demand. This is an inefficient method of irrigation and wastes water that we are trying to conserve.
Mulching is essential for gardening along the Front Range. Mulch helps keep plants roots cool, prevents soil from crusting, minimizes evaporation and reduces weed growth. Mulches also give beds a finished look and increase the visual appeal of your garden.
Organic mulches, such as bark chips, pole peelings or wood grindings, should be applied at least 4 inches deep. Because they decompose over time, they're an excellent choice for new beds. As plants mature and spread, they'll cover the mulched areas.
Another amendment to be careful with is wood mulch. All to often wood mulch piled up around the base of a species will cause the plant to rot at the base and die. Rock mulch works much better but one must still be careful to not pile it up around the base of the plant or crown rotting may still occur.
Inorganic mulches include rocks and gravel, and should be applied at least 2 inches deep. They rarely need replacement and are good in windy spots. However, they should not be placed next to the house on the sunny south or west sides, because they tend to retain and radiate heat. If rock mulch is used in this forum, the plant species selections need to be the type that will like the extra heat that this type of exposure will provide. You may be able to grow plant species that are marginally hardy for the region in these situations. This gives the gardener another chance to expand the plant palette. Experiment and have fun doing it and learn as much from failures as successes. Mulch may be applied directly to the soil surface or placed over a landscape fabric. (Note: Do not use black plastic because it prevents air and water from reaching to the plant roots.)
6. Turf Alternatives
Traditionally, the landscape of choice along the Front Range has been a carpet of bluegrass turf. Bluegrass is lush and hardy, but in our semi-arid climate it requires a substantial amount of supplemental watering.
Good, xeric design does not mean that turf grass cannot be used. With proper preparation of the soil and a conscious effort at soil preparation lawns can be a component of xeric landscape design. Just remember to keep the lawn component to a minimum and site your lawn where you can enjoy it easily from your home.
One way to reduce watering requirements is to reduce the amount of bluegrass turf in your landscape. Native or low water-use plantings, patios, decks or mulches can beautify your landscape while saving water. Choosing a turf that uses less water also serves the same purpose. Such choices can include buffalo grass, blue grama grass, turf-type tall fescue and fine fescues.
7. Appropriate Maintenance
Preserve the beauty of your Xeriscape with regular maintenance. The first year or two, your new landscape will probably require a fair amount of weeding, but as plants mature they will crowd out the weeds, significantly reducing your maintenance time.
In addition to weeding, your Xeriscape will need proper irrigation, pruning, fertilizing and pest control. Maintenance time for a new garden is similar to a traditional landscape, but it decreases over time. In addition to weeding, proper irrigation, pruning, fertilizing and pest control will keep your landscape beautiful and water thrifty. When your garden is well taken care of, you can sit back and enjoy it.